Slide & Stop Gates - SERIES G,N
The slide gate assemblies shall be manufactured by Halliday Products, Inc. Orlando, Florida. The dual slot frame shall be a one-piece 1/4" (7mm) thick 6061-T6 aluminum extrusion weighing 4 lbs. per foot (6 kg. per meter) and with a continuous embed or mounting flange as required. The aluminum frame shall incorporate a one-piece extruded polymer channel liner. The handwheel shall be 16" (406mm) diameter cast aluminum and work in conjunction with a brass lifting nut and 1 1/2" (38mm) diameter stainless steel acme rod. All hardware shall be stainless steel. The lifting nut shall be provided with a grease fitting for ease of lubrication. Polymer bearing pads shall be incorporated above and below the brass nut. The gate shall be 1/4" (7mm) thick 6061-T6 aluminum and reinforced to deflect no more than 1/360th of the span. The slide gate shall have a flush bottom closure and bottom seal. The handwheel, gate, and stem shall be removable. Unit shall be guaranteed against defects in material and/or workmanship for a period of 3 years.